If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes!
An older thread, but there have been several of these cut & rub sessions.
All were done just before the Consumer Electronics Show, held in Las Vegas.
Lots of good information and good times with some of the guys from MOL!:
2005 CES Alpine Electronics X5 Ultimate Listening Machine:
We encourage MOL members to show off their latest before & after results. We also welcome "Work in Progress" Threads. For Enthusiasts or Professional Detailers
We encourage MOL members to show off their latest before & after results. We also welcome "Work in Progress" Threads. For Enthusiasts or Professional Detailers
We encourage MOL members to show off their latest before & after results. We also welcome "Work in Progress" Threads. For Enthusiasts or Professional Detailers
We encourage MOL members to show off their latest before & after results. We also welcome "Work in Progress" Threads. For Enthusiasts or Professional Detailers
Kevin Brown
NXTti Instructor, Meguiar's/Ford SEMA Team, Meguiar's Distributor/Retailer
This is my second write-up here at Detailing World. I wrote about this project several months ago elsewhere. You guys here on DW post using a lot of pictures, so I thought I would, too. I am here to contribute to the site, after all. This was the fourth Alpine project I was involved with...
Kevin Brown
NXTti Instructor, Meguiar's/Ford SEMA Team, Meguiar's Distributor/Retailer
Comment