Tweet
You can repair the scar of the paint or lampshade by instant glue!
It's more convenient than the clear!!!
For example:
===================================================
The switch of the original is with white fogged characters and heavy plastic smell...
Rub it to be a little bit fogged
use spray gun
prepare watercolor
prepare gas mask
After polishing and modified averagely with cotton
Applying the instant glue to the switch as averagely as possible with sharp kneaded paper
Try hard to scribble a bit more evenly, otherwise it is very difficult to rub after a moment, this fails a bit ...
Rub flat slowly with 2000# sandpaper , polish and check it over
Rub again and again to your satisfaction.
mend a little more glue to the sunken place, did not need to rub to hard…
this was the second time that I had done.
to rub sunken place to be flat, the red words became white again, come over those steps for one more time. Damn it !!
How to polish it into the surface of the mirror?
It is enough to use polishing compound of M83
500RPM
OK~
Finally, put the metal lid back to the switch.
It's more convenient than the clear!!!
For example:
===================================================
The switch of the original is with white fogged characters and heavy plastic smell...
Rub it to be a little bit fogged
use spray gun
prepare watercolor
prepare gas mask
After polishing and modified averagely with cotton
Applying the instant glue to the switch as averagely as possible with sharp kneaded paper
Try hard to scribble a bit more evenly, otherwise it is very difficult to rub after a moment, this fails a bit ...
Rub flat slowly with 2000# sandpaper , polish and check it over
Rub again and again to your satisfaction.
mend a little more glue to the sunken place, did not need to rub to hard…
this was the second time that I had done.
to rub sunken place to be flat, the red words became white again, come over those steps for one more time. Damn it !!
How to polish it into the surface of the mirror?
It is enough to use polishing compound of M83
500RPM
OK~
Finally, put the metal lid back to the switch.
Comment