Need help with Subaru Paint - Pics Attached

[76Celica]

Re: Need help with Subaru Paint - Pics Attached

can i use the D.A with UC then D.A 205 or use a different polish?

[Shawn T.]

Re: Need help with Subaru Paint - Pics Attached

205 on a W9207 pad would really bring out clarity in the finish. If you have the time, I would definitely do it.

[76Celica]

Re: Need help with Subaru Paint - Pics Attached

1- (D.A) UC on a W8207 pad
2- (D.A) 205 on a W9207 pad
3- NXT wax by hand?

[Tuck91]

Re: Need help with Subaru Paint - Pics Attached

1- (D.A) UC on a W8207 pad
2- (D.A) 205 on a W9207 pad
3- NXT wax by hand?

You can use M205 with a W8207 polishing pad if you want to.

I like to apply my LSP by hand, but you could still apply NXT with a W9207 finishing pad at speed 2 or 3.

[Bill Davidson]

Re: Need help with Subaru Paint - Pics Attached

Nick (Tuck91), what do you think about using a 7207 cutting pad and UC with the DA and then following it up with an 8207 pad to repair the micro damage done by the 7207 pad? I know it's not normal procedure. Even if this wouldn't be recommended, I like to know why not. I'm just thinking about the cost savings. If the OP does want to but M105, this would be a cheaper route.

I personally would order some M105 if I were making an international order, just to have it, in case it's needed. That being said you could likely still get the job done with UC, you'll just have to work a little bit harder.

[76Celica]

Re: Need help with Subaru Paint - Pics Attached

Hey all. I have completed the detail but funny enough when I looked at the defects on the before pics I didn't note where they were originally and I couldn't find them anymore! I have taken heaps of shots though and a new thread is here:
Thanks for looking
http://meguiarsonline.com/forums/sho...subaru+outback