If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a customer with a black clk430 and it initially had some pretty heavy swirls. It required using the rotary, cutting pad and M83. Finished off with M80 and the PC.
-Bob
NXTti graduate, Meguiars Ford/SEMA Team
"All Corvette's are red, the rest are mistakes" - John Heinricy (Corvette Engineer)
I had to use a rotary + 8006 + M83, and the same combo with M80 on a friend's Infinity G35 couple once... 8 hours later about 40% of the swirls still remained... That was probably the toughest detail I've done so far...
Comment