• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

"Woodie" exterior wood care

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • "Woodie" exterior wood care

    I know this is a "paint" forum, but what about steps for taking care of varnished (NOT polyurathene) exterior wood on a woodie? I have some slight "pecking" almost like sandy surface that is very slight, but want to retain the gloss finsih. What do I do???

  • #2
    Re: "Woodie" exterior wood care

    Is this "pecking" something that is above the surface or below it. Do you have a picture or description of the type of surface you are working on?

    Comment


    • #3
      Re: "Woodie" exterior wood care

      Hi Tom,

      Well it is above the surface and feels like a rough overspray. It could be from a faulty nozzle that spit out globs instead of a fine mist, but the 4 other coats of Epifanes sandless high gloss varnish went on fine, with no blemish, just the last coat, then I stopped.

      I did steel wool between coats (0000 gauge) to break the surface and avoid clouding that varnish tends to do during build-up, attached is an OLD pic before sanding to bare wood, bleaching and smoothig then varnish. Only one I have at the moment.

      ?????? what's next?

      Comment


      • #4
        Re: "Woodie" exterior wood care

        Based on my varnish experience, I would sand the varnish with very fine sand paper, then rub it out. I used a brush to apply all the varnish on my car and after the 5th coat I sanded between each coat. I have about 15 coats on the car. I actually wet sanded my last coats and the "rub out" was done with a polish not a cleaner. Such as our #9 Swirl Remover or our M82 Polish.

        ~Tom

        Comment


        • #5
          Re: "Woodie" exterior wood care

          O.K. let me see if I have this..... sand, coat with a brush (gotta find a good one), dry, sand, repeat..... then wet sand and finish with a swirll remover? Looking for the deep gloss opalessance and luster found on woodies I lust after. What about the type of varnish I am using, sticking to the thin down ratio as describe elsewhere (NWC forums). Any other bits of advice? At the completion will Number 7 keep it looking good, or should I switch to something else?

          Thanks for your help!

          Comment


          • #6
            Re: "Woodie" exterior wood care

            Why don't you give me a call tomorrow during the day and we can discuss in further detail. Plus, I want to hear more about the car you are doing.

            You can reach me at 800-854-8073 ext. 117 Pacific standard time.

            Regards,

            Tom

            Comment


            • #7
              Re: "Woodie" exterior wood care

              Thanks, will do. I posted a pic of the Morris 8 woodie on the gallery page. Had a hard time trying to post one on the message.

              Cheers,
              Jeff

              Comment

              Your Privacy Choices
              Working...
              X