Tweet
Will the polymers "set up" or crosslink properly if the car is covered immediately after waxing with NXT, or is it best to leave it uncovered during this process?
Thanks
Thanks
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Hi bumboola,
Welcome to Meguiar's Online!
The answer to your question is uncovered. As in, apply the wax, allow to dry to a haze, this is usually 10-15 minutes, then remove the wax and then your done. You don't need to cover the car. I'm pretty sure what you want is time to pass and the polymers that have been left behind to be exposed to air.
Mike
Comment