Tweet
I applied #40 to the interior of my Stealth and it looks great; however, it left streaks on the dash of a VW Beetle. I buffed at it with a microfiber after it dried some, but I could still see the streaks. How can I prevent streaks from occuring?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: #40 Streaking
Sometimes you get streaking from #40 when you overuse it.
Try to apply a little less product next time and everything should be fine. -
Re: #40 Streaking
First, be sure to shake this product well before using it.
Next, apply and work this product over the surface and work it in well, then before it can dry wipe off any excess using a clean microfiber.
Modern vinyl and plastics tend not to absorb liquids very well so a lot of times when you apply a dressing it tends to be very topical, that is it mostly affects the surface, for this reason you want to make sure you wipe any excess off.
So apply, work in and then wipe off while the product is still wet on the surface. Use a carefully manner when applying any product to any interior component.
Hope this helps...Comment
-
Re: #40 Streaking
Thanks and glad to see you're stayingComment
Comment