2002 Kompressor with M21 x 2

[Mike Phillips]

2002 Kompressor with M21 x 2

[Ranger72]

Sharp!

[Mike Phillips]

Here's a couple more...

[imacarnut]

great job mike! i would buy you a beer if you lived closer!!

[Xtreme99_s-Dime]

And I would buy you another beer... if I were old enough to buy one!!!!!

Looks great,

Stephen

[LnkPrkSoldier]

and i'd buy you a beer regardless of me being underage. looks nice. those benz's are quite nimble around the corners. not as strong in the straights as other benzs though but good car none the less.

[stealth]

XCLNT as always Mike! Difficult color too. I'm enjoying the view.

[Mike Phillips]

Before




Cropped out section from the above photo

[gb387]

Looks great! Nice work!

[rusty bumper]

Sharp as a tack.

[dino]

Looks great!

[toyotacamry99]

sweet work Dr. PHil

[Teak]

Excellent work. What was your process before applying M21?

Eric

[JSM]

What type of prep work did you do to remove and/or reduce the buffer swirls?

[Mike Phillips]

Originally posted by Teak
Excellent work. What was your process before applying M21?

Eric

3-step rotary buffer buff-out,

M84/W-7006/RB
M83/W-8006/RB
M82/W-9006/RB

Followed by M80 Speed Glaze with the G100, followed by 3 applications of M21 with the G100... 12 hours cure time between the first coat and the second coat and about 6 hours between the second coat and the third coat.

I probably have about 12-14 hours into the polishing work. It's as nice in person as it is in the photos. I'll be posting a very thorough write-up as I did a lot of sun shots after each step and after each step I wiped the finish down with a 50/50 mix of Isopropyl Alcohol and water to show the true condition of the finish. (Just for you Bill D )