Ford Mustang Bullit (Teaser)

[Erik Mejia]

Here are some pics of a newer Ford Mustang Bullit that Richard Lin (OctaneGuy), and I will be working on this saturday. I'll post the full writeup once we complete the detail.

Today I had just enough time to do the trunk lid, as well as a test spot of the rear quarter panel which had some nasty water spot etchings.

This is what I started with:
Note the right side was compounded using M105 and a wool pad, one pass.


Here are some afters:



Me using my halogen instead of the camera flash in this pic.


If you'll notice in this pic you can see where I wetsanded the brake light cover. This vehicle lives outdoors in the desert and the sun chewed the plastic up.


Here is a 50/50 of the water spots I was talking about:



More to come, so enjoy.

[Lexus Guy04]

Re: Ford Mustang Bullit (Teaser)

What products will you guys be using for that bad boy?

[Erik Mejia]

Re: Ford Mustang Bullit (Teaser)

What products will you guys be using for that bad boy?

Some Meg's, and some Prima.

[TimG]

Re: Ford Mustang Bullit (Teaser)

Sweet! Keep us posted

[J. A. Michaels]

Re: Ford Mustang Bullit (Teaser)

Looking good. Can't wait to see the whole car completed.

[Lexus Guy04]

Re: Ford Mustang Bullit (Teaser)

Awesome, keep us updated please!

[dragonballz]

Re: Ford Mustang Bullit (Teaser)

When you say "one pass", do you mean literally passed over once or do you mean you went through one polishing cycle on that section without applying more product

[Erik Mejia]

Re: Ford Mustang Bullit (Teaser)

When you say "one pass", do you mean literally passed over once or do you mean you went through one polishing cycle on that section without applying more product

I meant one polishing cycle on that section without applying more product.