Tweet
Opps!!
I waxed my truck with NTX paste this past week. Love the product by the way. Well I put the can on my hood and it slid off and hit the driveway. Again, great product. The next day I go to add another coat and the wax had been jarred from the can and now spins when I try to turn the applicator to load it up. Would it be ok to put the can in a pan of warm or hot water to melt it a little to get the wax attached again? Any suggestions?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
heat it up again.....that should do the trick for you
-
Hi holderp!.......Welcome to the forum.
r. b.Comment
-
Re: Opps!!
Sorry to open up quite an old thread here but can Tech Wax Paste be heated up safely using hot water or even the sun. Either to make it re-attach to the tin, easier to apply, or if it happened by accident by being left in a hot car for a few hours. I have read on the forums that NXT freezing is a really bad thing so surely heating is not so great either?Originally posted by PaBlkBrd View Postheat it up again.....that should do the trick for you
Also: A number of comments on the forum claim Tech Wax (liquid I suppose) is destroyed if allowed to freeze. Why is this - I assume the polymers get damaged in some way?
Just curious....
4RingsComment
Comment