Tweet
using multiple products
hi can you use m#7 then m#26 and finish with nx 2.0 or is the first two enough
thanks mark
thanks mark
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: using multiple products
If you wanted to use those three products in combination, I would recommend #7 first, then NXT, and finally #26.
NXT is fully synethic so it should be applied prior to M26 if you follow common logic. Sealant before Carnuaba.
I would do one half of your hood with M7, NXT, M26 and the other half with just M7, M26 and compare them. See if you see a difference in how they look or how they hold up, then go form there.Let's make all of the cars shiny! -
Re: useing multible products
Using M07 and then m26 would be a great choice. Since M07 is a pure polish with a good wax like M26. Or using the M07 with the NXT.2, which is what I use on my personal vehicles. is also a great choice. Using all three is up to personal choice. I personallly think you would not gain anything using the two waxes on top of one another.Sleepy
Love the Classics!Comment
-
Re: using multiple products
2 thin coats of wax is recomended, so you can certainly combine them to get that.
Perhaps your best bet would be to do a panel in each combination, and see which you like best.2017 Subaru WRX Premium - WR BlueComment
Comment