Tweet
Angle of Attack
What is the best angle to use the rotary buffer?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: Angle of Attack
When buffing with foam pads,
Whenever you can hold the rotary buffer flat... do hold the rotary buffer flat. That is hold the buffer in such a way that the pad is flat to the surface.
Only when working on thin panels, edges, contours etc., do you hold the buffer/pad at an angle, or only use a portion of the pad to buff with. -
Re: Angle of Attack
What about a wool pad?Comment
-
Re: Angle of Attack
same way, but gets trickier when doing vertical panels. it's just a matter of practice to get used to it
" Sometimes logic is your friend (Mike-In-Orange)"Comment
Comment