Tweet
Does anyone have a detailed way of cleaning a pad during a detail. I have tried using a Megs detail brush with little success. Any help will be appreciated.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Miguel
"What you become directly influences what you get" -
I have pretty good success using a Micro Fiber towel against the pad with the maching spinning. It takes the excess and "gummyness" off the pad and allows me to keep working.
I have also rinsed a pad and then spun it out to keep working, but that was an extreme case, and it took a while for the water to get out of the pad.Comment
-
Thanks for the help guys.Comment
Comment