• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

G220 problem, please help!!.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • G220 problem, please help!!.

    Hi guys I have been using dare I say it my best purchase in a while. Untill today that is!!. Have just been doing a bit of minor correction work on my car a few light scratches.

    The speed seems to be dropping off and speeding back up. On investigation it seems the cord is to blame. Wiggle the cord and it works fine. So I decided to take the cover off and everything seems connected no loose wires etc... I decided to under the gripper that holds the cable in position and move it down a touch. And hopefully fingers crosssed I have sorted it. It seems fine now.

    Any hints and tips to get round this? Is this a common problem? MY G220 has covered approximately 50-60hrs use.

    Many Thanks in advance, Rappy.

  • #2
    Re: G220 problem, please help!!.

    Hi guys any help please?

    Comment


    • #3
      Re: G220 problem, please help!!.

      Did you check the carbon brush?

      Had the same incident and the culprit was (hopefully) them worn out carbon brush.
      Learning new things everyday

      Comment


      • #4
        Re: G220 problem, please help!!.

        No I never. How easy are the bushes to replace/check?

        Also, how much are they? Where can I purchase replacements from?.

        Comment


        • #5
          Re: G220 problem, please help!!.

          Comment

          Your Privacy Choices
          Working...
          X