So does that mean that you hurt something else?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
how to clean alternator
Collapse
X
-
NO! I did not hurt anything I have done plenty of other engines to and there never seems to be a prolem. By the way waht kind of Jeep do you have?
Jeff BurrowsJB's Executive Detailing "Protecting your investment"
Comment
-
Hey,
Just to chime in here....
We need to be careful; though some may not have had problems cleaning engines, there is a serious potential to do damage.
Some companies are releasing bulletins specifying products that are non-corrosive, to prevent damage to sensitive electronics. Another problem is that with the number of different materials under the hood, using just any engine degreaser could lead to damage, particularly with aluminum in the form of chemical etching. So while the engine may appear just fine, in a short time the damage may become apparent. Further, it is not the wiring so much, but rather the sensors that are the concern. Between the O2, MAF, ECM, etc... water on any of these could spell disaster. However, it is not only these sensors. I made reference to certain Nissan engines that have recessed spark plugs as well.
So while I love a clean engine, it would only be prudent that caution as well as every precaution should be used if you decide to clean the engine.
Just IMHO!
Tim
Comment
-
Just to chime in here, Tim's dead on when he says,
Originally posted by 2hotford
We need to be careful; though some may not have had problems cleaning engines, there is a serious potential to do damage.
So while I love a clean engine, it would only be prudent that caution as well as every precaution should be used if you decide to clean the engine.
Just IMHO!
Tim
Mike
Comment
-
Hey,
*JeepZJlover I think everyone reading this thread should realize that you are only 17 years old, and most likely have very limited experience in detailing engines. Therefore, it would be wise for members to take advice with caution.
Yes I have worked on many engines/drivetrains etc. My brother and father are both certified GM mechanics with a combined 49 years of experience. So, growing up in a family of mechanics does tend to have you fixing your own vehicle.
So while the O2 sensor is screwed in, the wire going to the sensor etc may become corroded if used with the wrong cleaner/degreaser.
Tim
Comment
-
on the alternator, i think the safest way of cleaning would be a scraper and some sand paper..... i wouldnt risk having to replace it because some cleaner and water got in it, and i would think a scraper and sand paper would do a good job if you have the patience
Comment
Comment