Tweet
Helllo everyone, hope you all are doing well. My question is what is the best way to hand rub hard areas to reach where the mini buffers can't get into. Besides the obvious method" rubing them by hand" is there a special compound I can use or a certain way to rub it out quicker and better? I'm stuck in a few hard to get areas (under cariage, engine bay, under side of hood etc. Thanks for the help.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: Hard Areas Need Loving Too!!!
maybe you could check and see the powerball system from mothers....
Hope this helps." Sometimes logic is your friend (Mike-In-Orange)" -
Re: Hard Areas Need Loving Too!!!
thanks for the tip I'll look into it!!!Comment
-
Re: Hard Areas Need Loving Too!!!
I recently purchased the powerball mini and used it in areas that the G100 wouldn't fit - A pillars, C pillars, parts of the outside mirrors, etc. I used M80 and it worked like a charm. Didn't leave any hazing or micromarring. I highly recommend the powerball mini for those tough to detail areas.A common mistake that people make when trying to design something completely foolproof is to underestimate the ingenuity of complete fools.
Comment
-
Re: Hard Areas Need Loving Too!!!
Thanks man I appreciate the help!!!Comment
Comment