Trans am hood decal

[AJB]

What Meguiar's product should I use to safely clean/polish the large eagle hood decal fitted to a Trans am?

Thanks
AJB

[JG_Detailing]

It shouldn't matter what polish and wax you use on the decal. Because if you have pinstriping on a car and you polish and wax over that and it doesn't do anything to it. So it should be ok to use Meguiar's Polish and NXT Tech Wax on it.

[2000]

Re: Trans am hood decal

Originally posted by AJB
What Meguiar's product should I use to safely clean/polish the large eagle hood decal fitted to a Trans am?

Thanks
AJB

are you using a pc? if you using a rotery stay away from pin striping ect. If you using a pc you should be ok, but you'll want to be careful of any edges, you could end up with a wax line all around the screaming chicken. I did one of these cars a while back for a friend and I had to take my finger nail all around the bird to get old wax deposits out from under the edge. I couldn't even get a brush with some QD to help get it. it took about an hour to do it. and where my fingers killing me. but to use polish and wax on the sticker itself you should be fine.

[JG_Detailing]

If you get wax on the edge of the bird try use some QD and Meguiar's detail brush it should get the wax out between the edge's.

[2000]

Originally posted by chevyman2001
If you get wax on the edge of the bird try use some QD and Meguiar's detail brush it should get the wax out between the edge's.

maybe it was this particular car, but I tried that and it didn't work. I would of needed to turn the brush upside down as the wax was mostly on the sticker and not the paint. any way point is its better to go slow and be care ful than fast and be slower because of clean up.