Tweet
I tried using UC and UP on my car this weekend and didn't have much success at removing swirls. Thankfully I only did test spot. No deep scratches, just swirls all over. I used my PC DA polisher with a yellow Meguiars pad when using the UC. I then used a white LC polishing pad when using the UP. I set speed to 5 at first then tried again at 6. I used a good amount of pressure and moved quite slowly over area. Any ideas of where to go from here?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment