How to remove???

[71RS Camaro]

I have used the Meguiar's scratch remover in the tube which results in swirl marks showing. I use a small soft rag when applying the scratch remover and don't know how to get rid of the swirlmarks.

Am I using it wrong or can someone tell me how to get rid of the marks after using the scratch remover??

Allen

[05PhillyStang]

I assume you're talking about Sctrach X? It's probably the rag. Try using a foam applicator to apply evenly over the surface, work it in really well (until it's just about clear) and wipe off using a microfiber towel.

[71RS Camaro]

Great,

Yes, that's the product,,,,

Ok, I'll try a foam applicator.....

Thanks for the response...

Allen

[Murr1525]

It can also take more than one application.. working it in, then applying again, working in, applying again.. a couple times, to get the best results.

[Mike Pennington]

71 RS Camaro...

Agree with what has been said...Sometimes ScratchX may take more than one application because it is a hand applied product, and is not super aggressive.

As far as your swirl marks go, it sounds as if they are coming from your applicator. Sometimes we tend to rub extra hard, and really use our fingers...this in combination with a tatty rag equals swirls....

YIKES !!!

Like 05phillystang said, use unifrom pressure wiht a high quality towel or applicator...

This should solves your problems.


Mike

[scrub]

Give this link a try too. How to remove a defect by hand with ScratchX

Good luck.