• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

Detailing around the valve stem

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Detailing around the valve stem

    I have some aluminum whhels. Polishing the wheel is not too hard, but when you finish the wheel, you'll nitice a little bit of dirty polish in the niche around the valve stem where you can't get to it with a towel. It's also too tight for a brush or even a chisel-point popsicle stick to get in there to get the polish out.

    Has anyone got a technique that works?
    Drive resposibly.
    Rock music.
    Tags: None
  • #2
    Re: Detailing around the valve stem

    Try a Q-Tip. If (even) that is too big, maybe hitting it with spritz of APC and strong blast of water.

    Bill

    Comment

    • #3
      Re: Detailing around the valve stem

      Get a mini polisher like the Dremil

      DetailingByM.com

      Comment

      Previous template Next
      Your Privacy Choices
      Working...
      X