Tweet
I was trying to remove a scratch but buffed too much and now my paint is burnt. Am I able to fix this? or will I have to repaint my whole door? 
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: How to fix burnt paint
As far as I know there is no fix for burnt paint except a repaint. -
Maybe. But try sanding it first to see if you damaged it compleatly through. You might be able to save it but most likely you have to re paint it. Good luck
Comment
-
Re: How to fix burnt paint
If you sand it you will go through the primer and land on bare metal. Looks like the edges are burned through. Make sure the edges are feathered, use paint prep to remove oils and layer some paint. The edges shoud be featherd from the buffer. After paint dries lightly sand the with sandpaper 3000 grit then apply some clear coat, sand again if necessary and buff lightly. It should blend nicely and may not even be noticable. I've made these repairs before with an airbrush it comes in handy but isnt required.Comment
Comment