• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

"Polishing" painted wheels

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    "Polishing" painted wheels

    Hi everyone! I'm a long time reader and a rare poster looking for some advice. I've got a set of polished aluminum SRT replica wheels on my Jeep. They are clearcoated. I intend to use UC, UP, and top them with Ultimate Wax. The faces of the spokes I can hit with my DA, but the inside flats I can't. Is it safe to use a Dynacone with UC or UP on the clearcoat of my wheels or will that scratch them up? The aim here is to remove any light scratches and get the most shine out of them. Thanks in advance!



    Tags: None
  • #2
    Re: "Polishing" painted wheels

    Bump?

    Here's a better shot:

    Comment

    • #3
      Re: "Polishing" painted wheels

      You can certainly use the products, but not sure about the cone on paint.

      I also found that the IronX helped with brake dust back in the barrel of the wheel that is harder to clean.
      2017 Subaru WRX Premium - WR Blue

      Comment

      Previous template Next
      Your Privacy Choices
      Working...
      X