Tweet
How should I prep the areas that I will apply Scatch Fix touch up paint
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: Prep for touch up paint
I would use a dedicated adhesive remover such as 3M's or equivalant to make sure everything is stripped clean from the surface. I wouldnt bother with an IPA solution.Practice doesn't make perfect, the dedication to achieve perfection makes perfect. "Smack"
2011 Jet Black 328i Touring
2007 Jet Black 335i Sedan -
Re: Prep for touch up paint
Thanks SmackComment
-
Re: Prep for touch up paint
If the scratch is down to metal make sure any rust is removed and apply thin coat of primer. You can get a small tube from most auto stores (duplicolor, etc). Make sure the scratch is clean of old wax or sealant and anything that was silicone based. Wash the area with APC, Dawn, etc or as suggested the 3M adhesive removal solvent. There are other alternatives that several auto stores carry including pre packed wipes with solvent. These will be either with the paint or where they keep bondo, etc. Regardless of what is used you want a clean surface but don't get so aggressive as to make the problem worse. No dirt, no rust, no silicone and the repair should adhere correctly. Allow the paint to cure for a few days and then you can go over with a small amount of compound, Scratch X, etc and VERY LIGHT touch to blend in the repair. Light touch is the key, otherwise you end up removing most of the touch up paint and will have to start over. Wait a couple of weeks and you can wax over the repair and surrounding area.Comment
Comment