Tweet
ULW suggests a second pass to ensure full coverage of wax. Do they mean after applying wax to rub it in again for coverage, or to apply/ remove then reapply and remove. Thankyou all!
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
Why walk through life when you can strut.
--- Tobymac -
Re: ULW/ A second pass?
Apply and remove, then apply again and remove again. -
It may be worth adding on to the post above me that waiting an extended period of time, such as over night, and then applying the next morning will achieve maximum effectiveness because the first layer will cure within that time frame.Always searching for the best....
Keep it country!
---------
SkiDoo Snowmobiles!Comment
-
Re: ULW/ A second pass?
Would you want to remove any dust with something like UQD first? I'm glad you said something Nick because I would have done a second coat right away!Comment
-
Re: ULW/ A second pass?
Apply and remove, just you did when you first applied the Ultimate Liquid wax. But for maximum benefit, follow the suggested 12 hour cure time, and do remember to remove any dust before repplying the wax. Ultimate Quik Detailer will come in handy here, even UQD recommends a 12 hour or at least overnight curing for maximum protection. The cure time required by some sealants can be annoying, but patience has its rewards.Comment
Comment