I am currently working on a project where I am just about finished wet sanding (1500 grit) and am about to start cutting/buffing. So I picked up a bottle of M105 a while back before I started this project. I am not sure what for, but I plan on using this as a first step with the maroon pad. I know alot of people follow this up with M205. But I have a good bit of the #9 swirl remover lying around and have been really happy with it in the past. I usually would follow up some of the over the counter rubbing compounds with the swirl remover and it did a great job. Can I follow up the M105 with the #9 swirl remover and yellow pad and get similar results to the M105/M205 combination since they are relatively close in the cut rating scale? The M205 is level 4 and the swirl remover is level 3. I realize it might take a few more passes, which I am fine with. I am also planning to follow this up with the machine glaze and the beige finish pad. Would that make sense.
Thanks!
Thanks!
Comment