Tweet
The paint on my 07 Tundra (white) was looking quite dull, so I used a clay bar and QD to rub out any surface contaminants, then went to work w/ UC.
I worked in sections ranging from around 1-2' at a time. I applied it w/ a blue terry/microfiber pad using a "gripper" handle (handle came w/ blue and white pads from Wal-Mart) in circular motions. I then applied a white microfiber pad from the gripper kit to the gripper to buff the excess and then wiped a final pass w/ a microfiber towel. I repeated that process for each section. I constantly adjusted my angle to the panels to see if any UC remained and it looked as if all was removed
I worked in sections ranging from around 1-2' at a time. I applied it w/ a blue terry/microfiber pad using a "gripper" handle (handle came w/ blue and white pads from Wal-Mart) in circular motions. I then applied a white microfiber pad from the gripper kit to the gripper to buff the excess and then wiped a final pass w/ a microfiber towel. I repeated that process for each section. I constantly adjusted my angle to the panels to see if any UC remained and it looked as if all was removed
Comment