Tweet
ive detailed all my cars by hand till now since im buying the DA g110v2. can you guys point me in the right direction as to what to do and what not to do while using it. i basically do not want to screw up my car lol
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: 1st time DA polisher user
Mike Stoops explained it really well so here's the link:
-
Re: 1st time DA polisher user
For starters, take a look on this site at the link DA Buffing 101 - An introduction to the G110v2 and similar tools.
Also, for further info find the DVD that Mike Phillips put out a few years ago.Comment
-
Re: 1st time DA polisher user
cool thanks guysComment
-
Re: 1st time DA polisher user
If you screw up your paint using a DA, then please, throw all your tools in the garbage can and never touch them again!
The only way I can imagine anyone not being able to use a DA is if they drop it from a ladder onto the vehicle or by dipping the foam pad in sand before applying to the paint.
JimComment
-
Re: 1st time DA polisher user
Just remember, if a pad hits the ground it's toast. That's about the only way to screw up with a DA. Good luck and enjoy the results.Best Regards,
ScottComment
-
Re: 1st time DA polisher user
Buying a DA is one of the best purchases you'll ever make and it literally pays for itself within it's first couple of uses. Here are some informative videos to check out.
Instructional Car Care VideosComment
-
Re: 1st time DA polisher user
Take your time and make sure you use the proper pads with the right cut polish. Hard to really mess up with a DA unless you have no clue at all to what you're doing lolComment
Comment