Tweet
The black bed cover and other plastic parts on my 2007 avalanche are begining to turn white, like they are dry. Any suggestions?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: 2007 Avalanche
I think chevy had a recall for these problems. Idk if it's still covered or if it needed to be in the 3/36 warranty or not thought... -
Re: 2007 Avalanche
I used ultimate protectant on my 07 and it took the color back to black with 1 application. I never got or saw a recall for the problem, but im in sunny California and do not have to worry about road salts in my area like you do.
Comment
-
Re: 2007 Avalanche
I also remember a recall about the cladding. I would check into it at your local dealer.
Otherwise I would give the Ultimate protectorant a shot at making it look new again.quality creates its own demandComment
-
Re: 2007 Avalanche
There's no recall, just a TSB on the issue. They may offer to replace certain parts if the vehicle is under warranty but a 2007, I doubt it at this point. The "official" fix from GM is use a product called Gatorback. I've used a product called Refinish Restorer to completely restore to the original, better than new condition. After that, using Ultimate Protectant, All Season Dressing, etc will keep it looking good.Black on Black - 2007 Chevy Avalanche Z71 4x4
Personalized Detailing
Comment
-
Re: 2007 Avalanche
Jay, Future floor wax for all the cladding. It's cheaper than AIO and will last longer. Also doesn't run when it gets wet.Comment
-
Re: 2007 Avalanche
Refinish Restore is a product to look at for alternative to Gatorback. http://www.chevyavalanchefanclub.com...061.0/all.htmlComment
Comment