vertical panels

[FRS]

How far do you guys go when doing paint correction/swirl removing on your vertical panels?

Do you go all the way down to the very end of the paint?

Where do you stop?

[J. A. Michaels]

Re: vertical panels

If you are referring to the bottom by the rocker panels. Yes, I go all the way down the sides. A lot of times this area is just as bad if not worse from debris kicking up from the road.

[FRS]

Re: vertical panels

Yes, I was referring to rocker panels (any of the sections of body paneling below the doors of an automotive vehicle ).

Do you use your DA for swirl removal down there?

[J. A. Michaels]

Re: vertical panels

Yes, I was referring to rocker panels (any of the sections of body paneling below the doors of an automotive vehicle ).

Do you use your DA for swirl removal down there?

Yes I do. I also have a mechanic's rolling seat, that I use for those areas. Saves on the back.