I have a 69 Road Runner that I am restoring and I have a few questions. It is a very original 383 4-speed Jamaica Blue car with a black vinyl top. I am having the vinyl top taken off and the whole car painted blue. I see some Road Runners with just the hood louvers painted black and the rest of the hood painted the same color as the car and I see others with the wide black stripe on the hood. Which is correct and how wide is each of the two stripes? Also, what color is the insert in the hood louver suppose to be? I see red, black, silver (no paint) etc. Where is a good reasonable place to get parts? Thanks in advance for your help. Bruce
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
1969 Road Runner
Collapse
X
-
Re: 1969 Road Runner
The original 1969 Plymouth Road Runner had the louvered hood as you describe but all came with the wide flat black stripes. The correct paint was Ditzler DDL-9355, (Black Organosol).
The stripe itself starts at the A-Post even with the edge of the cowl. It runs in a perfectly straight line the entire length of the fender then curls over the front edge.
The most important part is getting the center gap correct. The gap measures 11 1/4 inches wide evenly spaced off the centerline of the hood. The air scoops were also painted black to match. If the car was is equipped with the air grabber option then the grill mesh material within the scoops were painted Rally red.
Hope this helps!BobbyG
Comment
-
Re: 1969 Road Runner
BobbyG,
Very helpful, thanks! Do you have any suggestions on where to get parts reasonably for my 69 Road Runner...decals...emblems...gaskets for the hood inserts... thermostat choke...armrest supports...trunk mat...pad under hood...etc.? Thanks Again!
Bruce
Comment
-
Re: 1969 Road Runner
Originally posted by Bruce5 View PostBobbyG,
Very helpful, thanks! Do you have any suggestions on where to get parts reasonably for my 69 Road Runner...decals...emblems...gaskets for the hood inserts... thermostat choke...armrest supports...trunk mat...pad under hood...etc.? Thanks Again!
Bruce
I got these from the Internet and there are lots more as well.
BobbyG
Comment
-
Re: 1969 Road Runner
you could also try www.yearone.com its a big chevy site but i know they have mopar on there too.Zach Hall
2001.5 Dodge Ram 2500 Cummins Diesel - DD/Tow rig
1983 Chevy C10 - Race/Show rig
1939 Dodge D11 Luxury Liner Deluxe - Antique resto. project
Comment
Comment