Tweet
This is what I ended up using in lue of Hyper dressing. Now it's been brought to my attention that this could potentially be bad for the hoses and what not. Is there any truth to this?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
Re: ASD in the engine bay
Should be fine.
The usual concern with ASD would be a fire hazard if the car is turned on before the product has completly dried, and the solvents evaporated.2017 Subaru WRX Premium - WR Blue -
Re: ASD in the engine bay
I think HD tends to pick up less dirt/dust than ASD. That is why I typically use it in the engine bay.
I once put swirls in my paint just to see what it looked like.
I don't always detail cars, but when I do, I prefer Meguiar's.
Remove swirls my friends.Comment
-
Re: ASD in the engine bay
Originally posted by Andrew C. View Post
Agreed. Also as Murr stated, being that ASD is solvent based, one should allow the product to dry fully before driving the car. Personally, I stick to HD.
TimComment
-
Re: ASD in the engine bay
So yeah.... hoses will be fine unless they are on fire.....
2017 Subaru WRX Premium - WR BlueComment
-
Re: ASD in the engine bay
I'll probably just order some HD in my next round of purchases. Thanks for the quick replies!Comment
Comment