I am using a G110V2 with an orange LC pad. I tried spreading the polish on setting 1,2 and 5. Before I can spread it over an 18X18 area the polish dries up and turns into a dust. What is going on?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
M105 drying up
Collapse
X
-
Re: M105 drying up
Are you working in doors? On a cool surface? Is it extremely humid or hot outside? Is it hot in your garage? Have you clayed the surface yet?
All these factors could play into the product drying up sooner than faster.
Try work in the compound in a smaller space instead of concentrating on a larger space. If it dries up, try priming the pad first with a little bit of product or quik detailer, M34, or final touch. Also, you could spray all three of those products on the dried product to revive the dried product.
Hope this helps.
-
Re: M105 drying up
If it dries up, try priming the pad first with a little bit of product or quik detailer, M34, or final touch. Also, you could spray all three of those products on the dried product to revive the dried product.
Comment
Comment