Tweet
hi, i just paid a lot for a cruise control servo for my car. it is used (1989) and expensive lol what can i put on it to protect and preserve it all responses appreciated. bill
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: keeping rubber like new
You can protect the servo's physical plastic and rubber shell... but that is not going to prolong the life of the unit. The damage on the servo is caused by not only wear and tear, but also by the contaminations in your engine's vacuum system.
You can protect the rubber all you want, but that is not going to do anything to it. To protect the rubber boot, just spray it with silicone lube. This lube tends to leave little residue for sand and dirt particles to accumulate on. Even with the dirt entering into the cable, that would not decrease the life of the servo significantly, if at all.
Comment