Tweet
since this is 3 in 1 - if you follow with say nxt 2.0 - do you need to let it sit the 15 mins. I have practiced on my car over the last week or so and I have applied the nxt 2.0 right after removing the 151. - any thoughts on this method?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: 151 (relating to the wax portion)
I would think that the cleaners in NXT2.0 would remove some of the protection left behind by 151. So, waiting until the 151 wax fully set in my opinion would be a waste. I would apply a thin coat of 2.0 and if you have time, wait the 12 hours for the polymers to setup then apply another thin coat to ensure proper coverage.Originally posted by jmitch8011 View Post -
Re: 151 (relating to the wax portion)
Sounds fine. D151 is made for quick removal. NXT 2.0 will yield better protection that the D151 anyways.
NXT 2.0 though does need to dry before removal and then cure for 12-24 before the paint is touched again.
Comment
Comment