Tweet
I'm applying scratchX then #9 on my swirled car. How much pressure should I put when I apply them, I'm doing this all by hand btw.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
I'd say more than just light buff. I use a little pressure and switch the direction of passes. Like side t side a bit then front to bask a bit. Check this out
ScratchX how to
Good luck
Comment