Tweet
Ok so I want to use these products with a 7424 with a 8006 pad to remove slight scratchs. How lond do I work the prduct for before I wipe it off? I am working 2x2 area as well. Thanks.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: 80 and 83.
Work the products untill they break down and become clear.
This thread shold help.
Using the G-100 to remove swirls with the Professional LineYou left out licking the water off. Oh, wait a minute, that's my cat, not my car. Uh, I mean my cat licks himself dry. I don't lick my cat dry. Or my car. -PC. -
Re: 80 and 83.
In most cases, when working a 2x2 area, you can usually make 2-3 passes in at least 2 directions, for sure 2 passes in 2 directions, M80 is a much wetter product, while M83 is less wet, so you lose some lubricity faster with M83 and this makes it harder to buff longer.
Buff 2-3 passes in at least 2-3 directions, like the diagram in the How To forum.
That should be adequate for this product and what you're trying to accomplish, if the surface defects are not removed to your satisfaction, then wipe the surface clean, add fresh product and begin again.Comment
Comment