Tweet
I did a complete diamondplate toolbox makeover. Head over and tell me what you think
You will be surprised! I know I was
Dimaond plate Success!! NXT style
You will be surprised! I know I wasDimaond plate Success!! NXT style
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
Very nice right up and good lookin toolbox now
-
How did you attach the polishing wheel to your Makita polisher. I would like to try that.
ThanksComment
-
I used this little adapter I got from Eastwood Company The wheel is held in place by the two flat washers and bolt. It is a standard 5/8-11 thread to fit most rotaries, even the cheap ones.
Here is a direct link to the adapter
Rotary Adapter
And dont forget to get one of these wheels, I used an 8" which worked very very well
Treated Buff Wheel
Comment
Comment