Tweet
My G100 polisher finally gave up the ghost after 25 years. Great polisher over the years. So I am wondering if the backing plate (W68DA) would fit the MT300 polisher. What I saw was that both are 5/16" so I think it will work. Or will I also have to buy a new backing plate? Also I have a bunch of 5" pads, assume they will fit no matter which backing plate works with the buffer?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.