I am sure this question has been answered before, but my search for an older thread on the topic has come up empty.
Last week while using the DA, the Velcro on my W64DA backing plate separated from the foam rubber. Does anyone know why this happened? The backing plate is probably 4 years old; could the adhesive have just failed due to age? Also, is there any way this can be repaired? I thought about buying a can of 3M Super 77 adhesive, but I am not sure if it would provide a good bond between the Velcro and foam rubber, if it would stand up to the heat, etc.. I called Meguiar’s customer service yesterday afternoon, the gentleman I spoke to was as helpful as could be, but he had not heard of this problem before and was not aware of any ‘fix’. I don’t mind buying a new backing plate if contact cement will not fix mine; I just want to make sure that if the failure was due to something I may have done incorrectly I don’t do it again. Any input would be appreciated. Thanks.
Last week while using the DA, the Velcro on my W64DA backing plate separated from the foam rubber. Does anyone know why this happened? The backing plate is probably 4 years old; could the adhesive have just failed due to age? Also, is there any way this can be repaired? I thought about buying a can of 3M Super 77 adhesive, but I am not sure if it would provide a good bond between the Velcro and foam rubber, if it would stand up to the heat, etc.. I called Meguiar’s customer service yesterday afternoon, the gentleman I spoke to was as helpful as could be, but he had not heard of this problem before and was not aware of any ‘fix’. I don’t mind buying a new backing plate if contact cement will not fix mine; I just want to make sure that if the failure was due to something I may have done incorrectly I don’t do it again. Any input would be appreciated. Thanks.
Comment