Tweet
Hello every one!!! I have a question on the initial buffing after wet sanding. You are done sanding at 3000 then you buff the finish with the wool pad and diamond cut. I want to know what happens after you're done with that step and buff again but with the foam cutting pad and diamond cut? I have done it before it looks like the finish comes out much better, or is it just me? Does any one else do this? or is this what the Solo sytem is for?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: one step two moves!!!
Diamond cut is for wool pads only, read this to see a suggested plan to follow... or use the Solo system for the entire process.
Switching from 3M to Meguiar's - Rotary Buffer Questions? -
Re: one step two moves!!!
I have successfully buffed out 3000 grit sanding marks with a medium aggressive polish, and a compounding pad. This was done on an acura, and a lexus, both with softer clears. I think the diamond cut was a little more than needed.Superior Detailing - For All Your Auto Reconditioning Needs.
Metro DetroitComment
Comment