• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


No announcement yet.

Applying Hybrid Ceramic Wax

  • Filter
  • Time
  • Show
Clear All
new posts

  • Applying Hybrid Ceramic Wax

    I did a indepth clean on my 2017 ATS-V. I used Meguairs Wash/Wax car wash, powerwasher, and finished with a claybar to remove all roughness from the paint. I then applied the Hybrid Ceramic wax paste with a DA buffer. I used the buffer at a low speed soft foam pad for waxing(2) and applied one panel at a time. When I would complete 1 panel then I would buff off the previous panel with a microfiber towel.

    The paint was very smooth. First time in the rain the water did bead up nicely but it didn't repel dirt and grime as well as expected. I washed the car yesterday and noticed that exhaust particules still sticked to the car, and after washing yesterday the paint feel as if it wasn't waxed or claybared just a few weeks ago.

    Does this product need to be applied by hand for best results? How long should it last? Any other tips to get a good coating? Should I let it flash off for an entire day perhaps?
gtag('config', 'UA-161993-8');