• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

What would these require?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • What would these require?

    Picked up a car that needs a lot of elbow grease, but has a great potential. These are the worst spots on the entire car. From the looks of it, do you think they will come out? Is wet sanding in order? Or would 105/205 on a rotary take care of that? (Horizontal mark right above the pinstripe on pic 1 is a bad reflection), Picture 2&3 is the same spot.

    Thanks!








  • #2
    Re: What would these require?

    I think most or all would come out. They're similar to the ones I just corrected under the gas door of my Explorer.






    I was using the DA Microfiber system, but I think 105/205 would work fine.

    Is that a Taurus?
    2000 Ford Explorer XLT "Deuce"
    2007 Toyota Camry XLE

    Comment


    • #3
      Re: What would these require?

      Ouch, that's going to be a PITA to get out lol. DA-MF kit should do the trick.

      Comment

      Your Privacy Choices
      Working...
      X