This is the first time I have applied SwirlX with my Porter Cable Polisher. This pic is my third 16x16 area on the hood, which I broke into 9 areas. I used the "clean on the fly" with a terry cloth being held by hand up to the moving pad. I did this method after both of the prior sections. When on this section the PC started throwing off little bits of product all over the place when I switched to speed 5 (see pic). Is this normal with SwirlX? Am I doing something wrong? Too much product? Too little product? Also it is about 45-50 degrees F in my garage, could that have something to do with it? Thanks

Comment