Will a PC work ok on the front end of a Ram?

[Ringwraith]

I'm going to be buying a G-100 or PC soon and was wondering if I'll have problems working on my 04 Ram? How do you go about areas like the front end? There's lots of curves so I was just thinking those areas might be hard to do with a machine?? Or even the hood & front fender where it rounds over. I'm going to pick up Mike video so maybe it covers it there?

Thanks
Sean

[Mike Phillips]

Re: Will a PC work ok on the front end of a Ram?

When it comes to machine cleaning and polishing, you pretty much just get what you can get and do the rest by hand. The pad will stop spinning and only oscillate/vibrate when it's placed against or into tight areas, sharp curves, etc., so the cleaning aspect is greatly reduced in these areas.

Nature of the machine.

[Freddy]

Re: Will a PC work ok on the front end of a Ram?

And a little warning.
If you use a machine on a curved area, the surface area of the machine that touches the car is smaller.
So there is a bigger risk that you do some damage to the paint.

[Ringwraith]

Re: Will a PC work ok on the front end of a Ram?

Thanks guys

Sean

[MaximusZTS]

Re: Will a PC work ok on the front end of a Ram?

what is it that I have heard echoed around here in the past?

"You never know what you can do until you try"

[Hemin8r]

Re: Will a PC work ok on the front end of a Ram?

I've used the DA on my Ram with no problems. Once you get going on it it'll be simple to figure out how to move the machine around those tough spots.

[SVT Lightning]

Re: Will a PC work ok on the front end of a Ram?

IHow do you go about areas like the front end? There's lots of curves so I was just thinking those areas might be hard to do with a machine?? Or even the hood & front fender where it rounds over.

Maybe you should just trade up and get a Lightning!!!! Not as many curves and such on the front end. Just kidding.....NICE TRUCK!