Tweet
i have a black and decker pw1470 and bosch aquatak 33-11,and i dont know if the mtm or other foam lance can fit in these two electric pressure washer.what can you advise guys.thanks in advance
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
-
-
Re: pressure washer fittings
I believe that the quick connect on most pressure washers is 3/8 inch so you should be fine. Worst case is that you would have to change the male end on the foam lance which is very easy. You can buy the quick connect fittings at most hardware stores for only a few dollars usually.
Comment