i just used my Metabo rotary first time last week for first time using rotary keep in mind first time touch a machine also i didn't used anything before no D/A or anything, i did nice job and i was really happy with the result, i used M83 with W7xxx maroon cutting pad @1500RPM. i noticed gumming then i know because of too much product i put. you can see my work i posted in (show you detailing section)
i was always read that the pad should be flat,at first couple passes i can't move the rotary correctly if the pad is flat, it was like vibrate & jumping, i angled the pad just very little then it worked fine.
now i am going to use M105/M205 for my second try. i read that using aggressive compunds with angled pad i will get hologram marks.i don't angle it too much just little millimeters.
any advices for using first time M105??, i am going to use it with maroon cutting pad.
i appreciate your advices guys.
i was always read that the pad should be flat,at first couple passes i can't move the rotary correctly if the pad is flat, it was like vibrate & jumping, i angled the pad just very little then it worked fine.
now i am going to use M105/M205 for my second try. i read that using aggressive compunds with angled pad i will get hologram marks.i don't angle it too much just little millimeters.
any advices for using first time M105??, i am going to use it with maroon cutting pad.
i appreciate your advices guys.
Comment