I have hard water spots on the textured black plastic shroud under my wipers on a 2009 honda accord coupe that i can not remove. Any suggestions on how to remove them without damage to the textured black plastic? Will vinegar work or will it harm or stain the plastic? If they cannot be removed, what product is the best to hide them and that is long lasting? thanks
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
hard water spots on black plastic
Collapse
X
-
Re: hard water spots on black plastic
I would use Megs Ultimate protectant. On my wife's MPV van i had a dealer installed black rear bumper protector. This piece looked faded and had severe water spotting.
I washed with APC+ (10:1), dried and applied a couple coats of UP over a week's time. It now looks brand new.
Recently my wife parked the van at work, someone was power washing something dirty & muddy and some of this muck got on the bumper protector....and as luck would have it...i did not have time to wash the van.....a few weeks passed....washed off the muck and the bumper protector looked good still.
Remember, just a small amount of product is all you need when applied with a foam applicator....I only used a couple quarter size blobs on a Meg yellow foam applicator pad....and a couple applications over a weeks time will do wonders for you."STRIFE" aka Phil
2005 Infiniti G35 Coupe (IP/ aka White) the Toy
2011 Subaru Impreza (SWP/ aka White) the DD
2017 Subaru Forester (CWP/ aka White) Wifey's
Comment
Comment