Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: Drying technique

          
  1. #1
    Registered Member
    Join Date
    Dec 2011
    Location
    Malaysia
    Posts
    24
    Rep Power
    6

    Drying technique

    Hi,

    I'm new to detailing. My second post here ever.

    Just wanted to get learn some tricks of the trade. I've noticed that I'm getting water marks from not drying the car thoroughly after washing. Problem is, I can't seem to dry it fast enough.. any faster and it won't be thorough enough.

    By the time I reach my last panel, its already half dried itself and leaving some water marks... BTW, I live in a tropical climate hence things do dry fast here!

    How do you guys tackle this problem?

    Paul

  2. #2
    Registered Member ChevyNick's Avatar
    Join Date
    Sep 2011
    Location
    Michigan
    Posts
    414
    Rep Power
    10
    Well I'm no expert in the drying area, but are you able to dry in a shaded area? That would probably help if you aren't. I wonder if its your water... Sometimes when I'm drying my truck, the opposite side will begin to dry, but no water spots are left usually. If there are any, they wipe away with a spray wax.
    Always searching for the best.... Keep it country!
    ---------
    SkiDoo Snowmobiles!

  3. #3
    Registered Member Meticulous-Detail's Avatar
    Join Date
    Nov 2009
    Location
    Stang Island, NY
    Posts
    791
    Rep Power
    15

    Re: Drying technique

    Are you using towels or a leaf blower? Did you try the flooding technique when rinsing the soap off?

  4. #4
    Registered Member Marc08EX's Avatar
    Join Date
    Aug 2004
    Location
    Glendale, AZ
    Age
    33
    Posts
    2,959
    Rep Power
    48

    Re: Drying technique

    Have you seen this video yet? Meguiar's Quik Tips Video Series Washing

    The main point you have to take from that video is using the sheeting method at the end of your rinse cycle. This will help reduce the amount of water beads on your paint's surface leaving you with less water to dry. That might not fully help you if it's really hot in Malaysia. I'm from Phoenix and I battle the same problem during 120F (50C) degree days. I get occasional water spotting at the last panels I'm drying during that time. However, I just hit the area with Ultimate Quik Detailer or a damp microfiber towel and the water spots go away. I've never encountered etched water spots from drying the car because I don't let that water spot stay there too long.

    Hope this helps.
    2011 Car Crazy Showcase SEMA Team

  5. #5
    Registered Member Murr1525's Avatar
    Join Date
    Oct 2004
    Location
    Pittsburgh, PA
    Age
    36
    Posts
    18,916
    Rep Power
    232

    Re: Drying technique

    Yeah, I would want to try drying with a QD spray, or UQW spray while going around.

    You also may want to try to do your first drying really fast. Then come back around a second time with the UQW and final drying wipe.
    2017 Subaru WRX Premium - WR Blue

  6. #6
    Registered Member Garage Troll's Avatar
    Join Date
    Jul 2009
    Location
    Sinking Spring Pennsylvania
    Posts
    601
    Rep Power
    14

    Re: Drying technique

    I know this really isn't a drying technique but I went to rinseless washes I don't have any more spotting. The flooding method, however, works really well.

  7. #7
    Registered Member JG_Detailing's Avatar
    Join Date
    Apr 2004
    Location
    Waynesburg, Pa
    Age
    45
    Posts
    1,799
    Rep Power
    35
    I know usually on hot days the car would dry faster then I can put the towel on it. I also use a California water blade on them to. That's a fast way to dry the vehicles off to. When I use that I also carry a towel with me to get the areas I can't get with the blade.

  8. #8
    Registered Member Poki's Avatar
    Join Date
    Jul 2008
    Location
    U.S.A.
    Posts
    547
    Rep Power
    18

    Re: Drying technique

    What are you using to dry with? The waffle weave microfiber towels work best for me. If it's hot out, after sheeting the water....I do a fast all around for the big spots the over again for the remaining water. These waffle weaves really soak up the water and leave no trails or drips behind.
    Barry

  9. #9
    Registered Member Focus RS's Avatar
    Join Date
    Aug 2011
    Location
    Sydney
    Posts
    21
    Rep Power
    6

    Re: Drying technique

    I have three things to say to you, leaf blower, leaf blower and leaf blower.
    WYSIWYG

  10. #10
    Registered Member Top Gear's Avatar
    Join Date
    Feb 2013
    Location
    Carolinas
    Posts
    842
    Rep Power
    13

    Re: Drying technique

    Two years after the last post and I also say "leaf blower" In fact, I can also say "water filter", "flood as best you can", and then "leaf blower".

    I used to spend a LOT of time carefully wiping dry, and that is just no way to live, especially when it's hot and humid out (here in the Southeast) and you can't even get the surfaces of a black car (or your body) dry for hours! Since I gave up the ghost and got a leaf blower, I've had no problem with water spots on the paint, and I've gained back so much of my time and sanity.

    With the water filter I've raved about in other threads, the housing has since blown out during an ice storm this past Winter (doh!), so I've been comparing not using it. I can't really tell the difference on the paint because of immediate blow drying, although if I let the water sit anywhere else without blowing dry, water spots form almost as bad as before. I also got a new industrial-quality garden hose, and that may have had at least something to do with it. I'm replacing the blown filter housing (and resuming with a 2 micron carbon water filter), because there are many places where the blower is not blowing dry that are still wet after a rinse or wash, leaving behind hard deposits.

    Regarding flooding, I was skeptical (because of having to turn off the water, remove a nozzle, etc) until I also got a new water nozzle which has a "shower" setting. This puts out a soft waterfall that doesn't splatter, so it gets pretty close to "flooding" as the others describe here in the forum. It at least this helps to reduce blower time a bit.
    Non-Garaged Daily Driver, DAMF System + M101, Carnauba Finish Enthusiast
    4-Step | Zen Detailing | Undercarriage | DAMF Upgrade |
    First Correction | Gallery

Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. UQW Technique
    By mattya802 in forum Detailing 101
    Replies: 19
    Last Post: Dec 9th, 2010, 02:21 PM
  2. Drying technique
    By HealthyCivic in forum Detailing 101
    Replies: 12
    Last Post: Feb 25th, 2010, 09:39 AM
  3. Question on drying technique
    By APR Tuned in forum Detailing 101
    Replies: 6
    Last Post: Mar 24th, 2009, 09:08 AM
  4. Chamois Drying Technique?
    By Ryan L. in forum Detailing 101
    Replies: 21
    Last Post: Dec 15th, 2006, 07:45 AM
  5. Replies: 5
    Last Post: Mar 18th, 2005, 07:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •