• If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

What's the difference between M80, M84, and M85 versus M105, M205, and M07 ???

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • #16
    Re: What's the difference between M80, M84, and M85 versus M105, M205, and M07 ???

    UP and M82 are probably pretty close in cut, but remember M82 is usually used with a rotary buffer so that process alone will likely give it a bit of an edge over UP. And of course, M82 is DAT while UP is SMAT so those differences exist too.
    Michael Stoops
    Senior Global Product & Training Specialist | Meguiar's Inc.

    Remember, this hobby is supposed to be your therapy, not the reason you need therapy.

    Comment

    • #17
      Re: What's the difference between M80, M84, and M85 versus M105, M205, and M07 ???

      Great clarification. Thank you.
      Paul Marmarinos
      Flawless Prestige Car Detailing
      "The trouble with the world is that everyone's about three drinks behind" - Humphrey Bogart

      Comment

      Previous 1 2 template Next
      Working...
      X
      gtag('config', 'UA-161993-8');