I'm talking about achieving a 99% correction on all painted surfaces, and fully detailing a car.
What tools do you use?
How long does it take?
How many segments/sessions, if any, does it take?
Background Story:
I recently just finished removing all the swirls in my paint. I had A LOT of deep rotary swirls from previous paint work to remove.
I use the G110 DA.
It took me 2 days to finish my roof, hood, front bumper and passenger side. Probably 12 hours each day, for a total of 24 hours. This was with UC, and M205.
A few months later, I finished the rear and driver's side. That took about 12+ hours straight. Using M105 and M205.
I feel that I am taking too long, but I don't know where my mistake is. Perhaps it's because I'm using a DA instead of a rotary? I would love to detail for dollars but I don't feel I could do a god enough job in 8 hours for one car.
What tools do you use?
How long does it take?
How many segments/sessions, if any, does it take?
Background Story:
I recently just finished removing all the swirls in my paint. I had A LOT of deep rotary swirls from previous paint work to remove.
I use the G110 DA.
It took me 2 days to finish my roof, hood, front bumper and passenger side. Probably 12 hours each day, for a total of 24 hours. This was with UC, and M205.
A few months later, I finished the rear and driver's side. That took about 12+ hours straight. Using M105 and M205.
I feel that I am taking too long, but I don't know where my mistake is. Perhaps it's because I'm using a DA instead of a rotary? I would love to detail for dollars but I don't feel I could do a god enough job in 8 hours for one car.
Comment